Hydrotech Acquires Isaacs
Hydrotech ecommerce supports the continental US only

SUN HYDRAULICS CORP
XRCLLANHU/S72499
Circuit Savers

Y-assembly

SUN HYDRAULICS CORP

MATERIAL:  XRCLLANHU/S72499

SUMMARY:  Y-assembly

Due to extremely high demand, please call 888-651-5712 for availability

This valve assembly provides 2 functions. It provides cross-port relief protection between ports 1 and 2. The solenoid valve vents both relief valves, dropping the pressure to a minimal level. This assembly is available in both normally open and normally closed options. The normally open H option means the pressure is at a low level until the solenoid is energized. The normally closed C option means the pressure is at a high level until the solenoid is energized.

  • The two ports marked 1 are common as are the two marked 2. The high pressure relief that is physically on the same side as port 1 controls the pressure on port 2 and vice versa.
  • The nature of a vented relief is that it brings the pressure up in a smooth manner. Unloading is abrupt.
  • This assembly is well suited to loading and unloading a motor.
  • The DAAL-*** solenoid valve extends approximately 1.18 (normally open valve) and 1.48 inches (normally closed valve) farther out from the manifold than the existing Parker valve. The DAAL-*** solenoid coil is not available with a ½ in. NPTF electrical conduit interface, as was the Parker/Waterman coil. If a ½ in. NPTF conduit interface is required, a DAAL-*** valve coil with ISO/DIN 43650 connector can be converted to ½ in. NPTF conduit interface by using a series P560D connector from Canfield Connectors (see www.canfieldconnector.com for details).

Capacity15 gpm60 L/min.
Body TypeLine mountLine mount
Mounting Hole Diameter.42 in.10,7 mm
Mounting Hole DepthThroughThrough
Mounting Hole Quantity22

Show FAQ

Additional Resources



Notes:
  • Important: Carefully consider the maximum system pressure. The pressure rating of the manifold is dependent on the manifold material, with the port type/size a secondary consideration. Manifolds constructed of aluminum are not rated for pressures higher than 3000 psi (210 bar), regardless of the port type/size specified.